AWD Warning does not Come ON
DESCRIPTION
Refer to "AWD Warning Light Remains ON".
Click here
![]()
WIRING DIAGRAM
Refer to "AWD Warning Light Remains ON".
Click here
![]()
Refer to "AWD Warning Light Remains ON".
Click here
![]()
PROCEDURE
CHECK HARNESS AND CONNECTOR
(a) Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.
OK:
No looseness at the locking and connecting parts
(b) Disconnect the O201 4WD ECU assembly connector.
(c) Check the connector case and the terminal for deformation and corrosion.
OK:
No deformation or corrosion
(d) Connect the O201 4WD ECU assembly connector.
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK 4WD WARNING MESSAGE
(a) According to the display on the GTS, read the Data List.
Chassis > Four Wheel Drive > Data ListTester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
4WD Warning Light |
AWD warning (multi-information display) |
OFF or ON |
OFF: Warning off ON: Warning on |
- |
Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
4WD Warning Light |
AWD warning (multi-information display) |
OFF / ON |
Observe combination meter assembly |
4WD Warning Light
4WD Warning Light
Result | Proceed to |
|---|---|
Data List display does not switch ON/OFF |
A |
Data List display switches ON/OFF |
B |
| A | REPLACE 4WD ECU ASSEMBLY |
| B | GO TO METER / GAUGE SYSTEM |