Engine & Hybrid System

Engine Hood Courtesy Switch Circuit

~2min read

DESCRIPTION

The engine stop and start ECU detects whether the engine hood is open or closed based on a signal received from the engine hood courtesy switch built into the hood lock with courtesy light switch assembly.

The engine stop and start ECU prohibits starting of the engine by stop and start control and changes the mode to "stalled" if the engine hood is opened with the shift lever in D or P while the engine is stopped by stop and start control.

WIRING DIAGRAM

For wire harness and connector inspection procedures and precautions, refer to

PROCEDURE

  1. READ VALUE USING GTS (HOOD COURTESY SWITCH)

NOTICE:

Before performing this step, check that the engine hood can be opened by pulling the hood lock control cable.

(a) According to the display on the GTS, read the Data List.

Powertrain > Stop and Start > Data List

Hood Courtesy Switch

OK:

GTS Display

Condition

Normal Condition

Hood Courtesy Switch

Engine hood closed

ON

Engine hood open

OFF

OK

CHECK AND ADJUST HOOD LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY FITTING (ADJUST HOOD)

NG
  1. INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY)

Click here

NG

REPLACE ENGINE HOOD COURTESY SWITCH (HOOD LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY)

OK
  1. CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH (HOOD LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY) - BODY GROUND)

(a) Disconnect the A58 engine hood courtesy switch (hood lock with courtesy light switch assembly) connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A8-1 (E) - Body ground

Always

Below 1 Ω

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK HARNESS AND CONNECTOR (ENGINE STOP AND START ECU - ENGINE HOOD COURTESY SWITCH (HOOD LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY))

(a) Disconnect the A169 engine stop and start ECU connector.

(b) Disconnect the A8 engine hood courtesy switch (hood lock with courtesy light switch assembly) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A169-7 (BNT1) - A8-2 (+)

Always

Below 1 Ω

A169-7 (BNT1) - Body ground

Always

10 kΩ or higher

A8-2 (+) - Body ground

Always

10 kΩ or higher

OK

CHECK AND ADJUST HOOD LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY FITTING (ADJUST HOOD)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR