Vehicle Interior

Entire Combination Meter does not Operate

~1min read

DESCRIPTION

This circuit is the power source circuit for the combination meter assembly. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source.

WIRING DIAGRAM

NOTICE:

  • When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
  • Inspect the fuses of circuits related to this system before performing the following procedure.
  • When replacing the combination meter assembly, update the ECU security key.

    Click here

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

(a) Disconnect the combination meter assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

I4-1 (EP) - Body ground

Always

Below 1 Ω

I4-2 (ES) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

I4-6 (IG+) - Body ground

Ignition switch off

Below 1 V

Ignition switch ON*1

11 to 14 V

Ignition switch ON*2

10.5 to 16 V

I4-5 (B) - Body ground

Ignition switch off

11 to 14 V

  • *1: for HEV Model
  • *2: for Gasoline Model

*a

Front view of wire harness connector

(to Combination Meter Assembly)

OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR