Steering Pad Switch Circuit
DESCRIPTION
The combination meter assembly and steering pad switch assembly are connected via direct line.
- The multi-information display in the combination meter assembly is operated using the switches of the steering pad switch assembly.
WIRING DIAGRAM
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- When replacing the combination meter assembly, update the ECU security key.
Click here
.gif)
PROCEDURE
INSPECT STEERING PAD SWITCH ASSEMBLY
Click here ![]()
| NG | REPLACE STEERING PAD SWITCH ASSEMBLY |
|
INSPECT SPIRAL CABLE SUB-ASSEMBLY
Click here ![]()
| NG | REPLACE SPIRAL CABLE SUB-ASSEMBLY |
|
CHECK COMBINATION METER ASSEMBLY (OUTPUT VOLTAGE)
*a |
Front view of wire harness connector (to Spiral Cable Sub-assembly) |
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
I82-11 (+DP) - Body ground |
Ignition switch ON |
4.8 to 5.2 V |
I82-10 (+DP2) - Body ground |
Ignition switch ON |
4.8 to 5.2 V |
| NG | GO TO STEP 5 |
|
CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BODY GROUND)
(a) Disconnect the I55 radio and display receiver assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
I55-20 (SWG) - I82-4 (EAU) |
Always |
Below 1 Ω |
I55-1 (GND1) - Body ground |
Always |
Below 1 Ω |
| OK | REPLACE RADIO AND RECEIVER ASSEMBLY |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)
(a) Disconnect the I5 combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
I82-11 (+DP) - I5-29 (MSM+) |
Always |
Below 1 Ω |
I82-10 (+DP2) - I5-12 (MSTI) |
Always |
Below 1 Ω |
I82-11 (+DP) or I5-29 (MSM+) - Body ground |
Always |
10 kΩ or higher |
I82-10 (+DP2) or I5-12 (MSTI) - Body ground |
Always |
10 kΩ or higher |
| OK | REPLACE COMBINATION METER ASSEMBLY |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |