Steering

EPS Warning Light Circuit

~1min read

DESCRIPTION

Use the following procedure if no DTCs are output but the EPS warning light is illuminated continuously.

The power steering ECU assembly controls the warning light in the combination meter assembly via CAN communication.

NOTICE:

When the power steering ECU assembly has been replaced, perform Power Steering ECU Initial Setting (assist map writing).

Click here

PROCEDURE

  1. CHECK VEHICLE CONTROL HISTORY (POWER STEERING SYSTEM)

(a) Enter the following menus: Chassis / EMPS / Utility / Vehicle Control History (RoB).

Chassis > EMPS > Utility

Vehicle Control History (RoB)

HINT:

The EPS warning light illuminates if any vehicle control history is stored.

Result

Proceed to

Vehicle control history not stored for power steering ECU assembly

A

Vehicle control history stored for power steering ECU assembly

B

B

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY

Click here

NOTICE:

After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.

A
  1. INSPECT COMBINATION METER ASSEMBLY

(a) Perform the Active Test of the combination meter assembly using the GTS.

Body Electrical > Combination Meter > Active Test

EPS Warning

(b) Check the combination meter assembly.

OK:

The EPS warning light turns on or off in accordance with the GTS operation.

OK

REPLACE POWER STEERING ECU ASSEMBLY

NG

GO TO METER / GAUGE SYSTEM