Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT POWER SEAT SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: Slide Switch
Tester Connection | Condition | Specified Condition |
q7-4 - q7-6 |
Slide switch pressed
(Forward) |
Below 1 Ω |
q7-1 - q7-12 |
q7-4 - q7-12 |
Off |
q7-1 - q7-12 |
q7-1 - q7-6 |
Slide switch pressed
(Rearward) |
q7-4 - q7-12 |
Front Vertical Switch
Tester Connection | Condition | Specified Condition |
q7-7 - q7-6 |
Front vertical switch pressed
(Up) |
Below 1 Ω |
q7-11 - q7-12 |
q7-7 - q7-12 |
Off |
q7-11 - q7-12 |
q7-11 - q7-6 |
Front vertical switch pressed
(Down) |
q7-7 - q7-12 |
Lifter Switch
Tester Connection | Condition | Specified Condition |
q7-8 - q7-6 |
Lifter switch pressed
(Up) |
Below 1 Ω |
q7-10 - q7-12 |
q7-10 - q7-12 |
Off |
q7-8 - q7-12 |
q7-10 - q7-6 |
Lifter switch pressed
(Down) |
q7-8 - q7-12 |
Reclining Switch
Tester Connection | Condition | Specified Condition |
q7-5 - q7-6 |
Reclining switch pressed
(Forward) |
Below 1 Ω |
q7-11 - q7-6 |
q7-7 - q7-6 |
q7-3 - q7-12 |
q7-5 - q7-12 |
Off |
q7-3 - q7-12 |
q7-3 - q7-6 |
Reclining switch pressed
(Rearward) |
q7-5 - q7-12 |
q7-10 - q7-6 |
q7-8 - q7-6 |
Lumbar Support Switch
Tester Connection | Condition | Specified Condition |
q7-9 - q7-6 |
Lumbar switch pressed
(Hold) |
Below 1 Ω |
q7-2 - q7-12 |
q7-2 - q7-12 |
Off |
q7-9 - q7-12 |
q7-2 - q7-6 |
Lumbar switch pressed
(Release) |
q7-9 - q7-12 |
If the result is not as specified, replace the front power seat switch. |
 |
*a |
Slide Switch (Front) |
*b |
Slide Switch (Rear) |
*c |
Front Vertical Switch (Up) |
*d |
Front Vertical Switch (Down) |
*e |
Lifter Switch (Up) |
*f |
Lifter Switch (Down) |
*g |
Reclining Switch (Front) |
*h |
Reclining Switch (Rear) |
*i |
Lumbar Support Switch (Hold) |
*j |
Lumbar Support Switch (Release) |
*k |
Component without harness connected
(Front Power Seat Switch) |
|
|
Was this page helpful?