Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
FRONT SEAT ASSEMBLY |
- |
- |
- |
- |
2 |
FRONT SEAT FRONT CUSHION SHIELD |
71868N |
- |
- |
- |
3 |
FRONT SEAT CUSHION SHIELD |
71812D |
- |
- |
|
4 |
SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
84921A |
- |
- |
|
5 |
RECLINING POWER SEAT SWITCH KNOB |
84921B |
- |
- |
|
6 |
SEAT ADJUSTER SHIELD CLAMP BRACKET |
72714 |
- |
- |
- |
7 |
FRONT POWER SEAT SWITCH |
84922 |
- |
- |
- |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch assembly removal/installation are shown below.
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
NOTICE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here ![]()
HINT:
- When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect / Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
*A: for Gasoline Model Front Camera System
Drivre the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
Stop and start system *A
Drive the vehicle until stop and start control is permitted (appoximately 5 to 60 minutes)
.gif)
- Learning completes when vehicle is operated normally
Effect / Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
- Learning completes when vehicle is driven
- Power seat is available only on the driver side.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here ![]()
2. REMOVE FRONT SEAT FRONT CUSHION SHIELD
Click here ![]()
3. REMOVE FRONT SEAT CUSHION SHIELD
Click here ![]()
4. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
![]() |
Click here |
5. REMOVE RECLINING POWER SEAT SWITCH KNOB
![]() |
Click here |
6. REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET
Click here ![]()
7. REMOVE FRONT POWER SEAT SWITCH

.png)
.png)
.png)