Brake

Installation

~1min read
010203040508.46N·mlb·ft
Tightening torque found on this page

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

PARKING BRAKE ACTUATOR ASSEMBLY

46310B

-

-

2

NO. 2 PARKING BRAKE WIRE ASSEMBLY

890C0A

-

-

3

REAR WHEEL

-

-

-

-

*1

O-ring

-

-

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf)

●

Non-reusable part

Lithium soap base glycol grease

-

-

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY

(1) Apply a light coat of lithium soap base glycol grease to a new O-ring.

(2) Install the O-ring to the rear disc brake cylinder assembly.

NOTICE:

Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.

(3) Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

Torque:

8,4 N·m {86 kgf·cm, 74 in·lbf}

2. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

NOTICE:

  • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this work.
  • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.

3. INSTALL REAR WHEEL

Click here