Vehicle Interior

Key Reminder Buzzer does not Sound

~3min read

DESCRIPTION

The key reminder warning buzzer sounds when the driver door is opened while the ignition switch is off or ACC. The key reminder warning buzzer is activated when the main body ECU (multiplex network body ECU) sends an un-lock warning switch signal and driver door courtesy light switch signal to the combination meter assembly via CAN communication.

WIRING DIAGRAM

NOTICE:

The key reminder warning system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the key reminder warning system after confirming that the communication systems are functioning properly.

Click here

PROCEDURE

  1. PERFORM ACTIVE TEST USING GTS (BUZZER OPERATION)

(a) Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Buzzer Operation (800Hz, Vol L, W/ Damping)

Combination meter buzzer

  • Frequency: 800Hz
  • Volume: Large
  • Fading tone

ON

-

Body Electrical > Combination Meter > Active Test

Buzzer Operation (800Hz, Vol L, W/ Damping)

Result

Proceed to

Combination meter buzzer sounds

A

Combination meter buzzer does not sound

B

B

REPLACE COMBINATION METER ASSEMBLY

A
  1. READ VALUE USING GTS (FL DOOR COURTESY SW STATUS)

(a) Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

FL Door Courtesy Switch Status

Front door courtesy light switch assembly LH signal

Close or Open

Close: Front door LH closed

Open: Front door LH open

-

Body Electrical > Main Body > Data List

FL Door Courtesy Switch Status

OK:

The GTS indicates ON or OFF according to the driver door conditions shown in the table.

NG

GO TO LIGHTING SYSTEM

OK
  1. READ VALUE USING GTS (KEY UNLOCK WARNING SW)

(a) Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Key Unlock Warning Switch

Un-lock warning switch signal

OFF or ON

OFF: Ignition key not inserted

ON: Ignition key inserted

-

Body Electrical > Main Body > Data List

Key Unlock Warning Switch

OK:

The GTS indicates ON or OFF according to whether the key is in the ignition key cylinder.

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG
  1. INSPECT UN-LOCK WARNING SWITCH ASSEMBLY

Click here

NG

REPLACE UN-LOCK WARNING SWITCH ASSEMBLY

OK
  1. CHECK HARNESS AND CONNECTOR (UN-LOCK WARNING SWITCH ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND BODY GROUND)

(a) Disconnect the I85 main body ECU (multiplex network body ECU) connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

I85-16 (KSW) - I13-1 (UN+)

Always

Below 1 Ω

I13-2 (UN-) - Body ground

Always

Below 1 Ω

I85-16 (KSW) or I13-1 (UN+) - Other terminals and body ground

Always

10 kΩ or higher

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR