Vehicle Interior

Terminals Of Ecu

~1min read

TERMINALS OF ECU

CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY

(a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly.

(b) Reconnect the power distribution box assembly connector.

(c) Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connectors connected.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

MB-13 (GND1) - Body ground

Ground

Always

Below 1 Ω

MB-14 (GND2) - Body ground

Ground

Always

Below 1 Ω

MB-26 (BECU) - Body ground

Auxiliary battery power supply

Ignition switch off

11 to 14 V

MB-27 (IGR) - Body ground

IG power supply

Ignition switch ON

11 to 14 V

(d) Install the main body ECU (multiplex network body ECU) to power distribution box assembly.

(e) Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol)

Terminal Description

Condition

Specified Condition

8F-3 (FLCY) - Body ground

Front door courtesy light switch (LH) input

Front door LH open

Below 1 V

Front door LH closed

11 to 14 V

I85-16 (KSW) - Body ground

Un-lock warning switch input

No key in ignition key cylinder

11 to 14 V

Key in ignition key cylinder

Below 1 V