On-vehicle Inspection
ON-VEHICLE INSPECTION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEEL
Click here ![]()
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
Click here ![]()
3. REMOVE FRONT DISC
Click here
![]()
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator with magnetic base, check for looseness near the center of the front axle hub sub-assembly. Maximum Looseness: 0.05 mm (0.00197 in.) NOTICE:
|
![]() |
(b) If the looseness exceeds the maximum, replace the front axle hub sub-assembly.
5. INSPECT FRONT AXLE HUB RUNOUT
(a) Using a dial indicator with magnetic base, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts. Maximum Runout: 0.05 mm (0.00197 in.) NOTICE:
|
![]() |
(b) If the runout exceeds the maximum, replace the front axle hub sub-assembly.
6. INSTALL FRONT DISC
Click here
![]()
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
Click here ![]()
8. INSTALL FRONT WHEEL
Click here ![]()

