On-vehicle Inspection
ON-VEHICLE INSPECTION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here ![]()
2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here ![]()
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here ![]()
4. REMOVE REAR DISC
Click here
![]()
5. INSPECT REAR AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator with magnetic base, check for looseness near the center of the rear axle hub and bearing assembly. Maximum Looseness: 0.05 mm (0.00197 in.) NOTICE:
|
![]() |
(b) If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.
6. INSPECT REAR AXLE HUB RUNOUT
(a) Using a dial indicator with magnetic base, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolts. Maximum Runout: 0.07 mm (0.00276 in.) NOTICE:
|
![]() |
(b) If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.
7. INSTALL REAR DISC
Click here
![]()
8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Click here ![]()
9. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here ![]()
10. INSTALL REAR WHEEL
Click here ![]()

