Engine & Hybrid System
On-vehicle Inspection
In this manual: Engine & Hybrid System
~1min read
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
(a) Connect the GTS to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the GTS on.
(d) Put the engine in Inspection Mode (Maintenance Mode).
Powertrain > Hybrid Control > UtilityInspection Mode
(e) Start the engine.
(f) Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank 1.
Powertrain > Engine > Active TestControl the Exhaust VVT OCV Duty Ratio Bank 1
(g) According to the display on the GTS, perform the Active Test and check the engine speed while operating the cam timing oil control solenoid assembly.
Standard Condition:
GTS Operation | Engine Condition |
|---|---|
0% |
Normal engine speed |
100% |
Engine idles roughly or stalls |
HINT:
- Refer to "Data List / Active Test" [Exhaust VVT Hold Learn Value Bank 1, Exhaust VVT Change Angle Bank 1, Exhaust VVT OCV Control Duty Ratio Bank 1 and Exhaust VVT Target Angle Bank 1].
Click here
.gif)
- Test not possible with the shift lever in P during charge control. Move the shift lever to N to perform test.
- If the DTCs are stored after the Active Test, clear the DTCs.
If the result is not as specified, check the cam timing oil control solenoid assembly, wire harness and ECM.
Was this page helpful?