Vehicle Exterior
On-vehicle Inspection
In this manual: Vehicle Exterior
~1min read
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSEMBLY
(a) Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Standard:
Washer fluid contacts the windshield in the areas shown in the illustration.
*a |
Upper Limit |
*b |
Standard |
*c |
Lower Limit |
- |
- |
![]() |
Measurement |
- |
- |
Standard Measurement:
Area | Measurement | Area | Measurement |
|---|---|---|---|
A |
224.9 mm (8.85 in.) |
B |
196 mm (7.72 in.) |
C |
92.6 mm (3.65 in.) |
- |
- |
If the result is not as specified, replace the washer nozzle sub-assembly.
Was this page helpful?
.png)