Vehicle Interior

On-vehicle Inspection

~1min read

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR

(a) Disconnect the h1 automatic light control sensor connector.

(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

h1-1 (CLTB) - h1-2 (CLTE)

Ignition switch off

Below 1 V

h1-1 (CLTB) - h1-2 (CLTE)

Ignition switch ON

11 to 14 V

Standard Resistance:

Tester Connection

Condition

Specified Condition

h1-2 (CLTE) - Body ground

Always

Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.

*a

Front view of wire harness connector

(Automatic Light Control Sensor)

(c) Connect the h1 automatic light control sensor connector.

(d) Connect an oscilloscope to terminals h1-2 (CLTE) and h1-4 (CLTS) of the automatic light control sensor connector and check the waveform.

*a

Component with harness connected

(Automatic Light Control Sensor)

*b

Waveform

OK:

Tester Connection

Condition

Tool Setting

Specified Condition

h1-2 (CLTE) - h1-4 (CLTS)

Ignition switch ON

2 V/DIV., 10 ms./DIV.

Pulse generation

(See waveform)

HINT:

The communication waveform changes according to the surrounding brightness.

If the result is not as specified, the automatic light control sensor may be malfunctioning.