Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
EGR COOLER ASSEMBLY |
25680 |
- |
- |
- |
2 |
NO. 1 EGR PIPE SUB-ASSEMBLY |
25601 |
- |
- |
|
3 |
EGR VALVE ADAPTER GASKET |
25629 |
- |
- |
- |
4 |
EGR INLET GASKET |
25628 |
- |
- |
- |
5 |
NO. 4 WATER BY-PASS HOSE |
16281 |
- |
- |
- |
6 |
NO. 8 WATER BY-PASS HOSE |
16296 |
- |
- |
- |
7 |
EGR VALVE ASSEMBLY |
25620 |
- |
- |
|
● |
Non-reusable part |
- |
- |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection after repair |
|
NOTICE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
HINT:
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Front Camera System
Drive the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE EGR COOLER ASSEMBLY
Click here ![]()
2. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
(1) Disconnect the EGR valve assembly connector.
(2) Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.
3. REMOVE EGR VALVE ADAPTER GASKET
4. REMOVE EGR INLET GASKET
5. DISCONNECT NO. 4 WATER BY-PASS HOSE
6. DISCONNECT NO. 8 WATER BY-PASS HOSE
7. REMOVE EGR VALVE ASSEMBLY
(1) Using the 8 mm socket wrench, remove the 2 bolts and EGR valve assembly.
.png)
.png)
.png)