Suspension

Removal

4steps
~24min
2/5difficulty
Done 0 of 4

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

REAR WHEEL

-

-

-

-

2

REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

89408C

-

-

-

3

REAR STABILIZER LINK ASSEMBLY

48840A

-

-

4

SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY

48740F

-

-

5

REAR COIL SPRING

48231B

-

-

-

6

REAR LOWER COIL SPRING INSULATOR

48258C

-

-

-

7

REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY

48740F

-

-

8

REAR NO. 1 SUSPENSION ARM ASSEMBLY

48720A

-

-

*A

for Gasoline Model

*B

for HEV Model

*C

for LH Side

-

-

*1

REAR SUSPENSION TOE ADJUST CAM SUB-ASSEMBLY

*2

NO. 2 CAMBER ADJUST CAM

*3

CAP

*4

REAR STABILIZER BAR

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension arm assembly removal/installation are shown below.

Necessary Procedures After Procedure Performed

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Rear wheel alignment adjustment

for HEV Model:
  1. Perform "Reset Memory"
  2. Perform "Calibration"
  • DTCs are stored
  • ABS warning light illuminates
  • Brake system warning light (yellow indicator) illuminates
  • Slip indicator light illuminates
  • Electronically controlled brake system does not operate correctly
for Gasoline Model:
  1. Perform "Reset Memory"
  2. Perform "Calibration"
  • DTCs are stored
  • ABS warning light illuminates
  • Slip indicator light illuminates
  • Electronically controlled brake system does not operate correctly
for Gasoline Model AWD:
  • Perform "Reset Memory"

Dynamic torque control AWD system

Suspension, tires, etc.

Rear television camera assembly optical axis (Back camera position setting)

Parking Assist Monitor System

Initialize headlight ECU subassembly LH

Automatic headlight beam level control system

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here

2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)

for LH Side:

Click here

3. REMOVE REAR STABILIZER LINK ASSEMBLY

Click here

4. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY

Click here

5. REMOVE REAR COIL SPRING

Click here

6. REMOVE REAR LOWER COIL SPRING INSULATOR

Click here

7. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY

NOTICE:

Hold the rear suspension toe adjust cam subassembly while rotating the nut.

(a) for Gasoline Model:

(b) for HEV Model:

8. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY

NOTICE:

Loosen the bolt with the nut secured.