Toyota Corolla Quiz
Introduction

Handling of hose clamps

In this manual: Introduction
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
4steps
~24min
2/5difficulty
Done 0 of 4
Toyota Corolla. Handling of hose clamps
  1. Before removing the hose, check the depth of the inserting portion and the clamp position in order to restore it surely.
  2. change a deformed or dented clamp for a new one.
  3. in case of reusing the hose, install the clamp on the hose where it has a clamp track.
  4. for a spring type clamp, adjust it by adding force to the arrow mark direction after the installation.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.