Toyota Corolla Quiz
Introduction

Removal and installation of engine intake parts

In this manual: Introduction
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
3steps
~18min
2/5difficulty
Done 0 of 3
Toyota Corolla. Removal and installation of engine intake parts
  1. If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.
  2. when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.
  3. when installing the inlet system parts, check that there is no mixing of a metal tip.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.