Toyota Corolla Quiz
Introduction

Removal and installation of fuel control parts

In this manual: Introduction
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
9steps
~54min
2/5difficulty
Done 0 of 9
  1. Place for removing and installing of fuel system parts
  2. work in a place with good air ventilation and without anything flammable such as welder, grinder, drill, electric motor or stove in the surroundings.
  3. Never work in a place such as a pit or nearby a pit, as there is a possibility that vaporized fuel is filled in those places.
  4. Removing and installing of fuel system parts
  5. prepare a fire extinguisher before starting the operation.
  6. For prevention of static electricity, install a ground on the fuel changer, vehicle and fuel tank, and do not spray much water so as to prevent slipping.
  7. Never use any electric equipment like an electric motor or a working light, as they may cause sparks or high temperature.
  8. Never use an iron hammer, as it may cause sparks.
  9. Dispose of the shop rag separately from any fuel deposit.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.