Toyota Corolla Quiz
Audio & visual

Radio receiver assy

In this manual: Audio & visual
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
10steps
~60min
3/5difficulty
Done 0 of 10
Replacement Рint

: components:

 1. Remove floor shift shift lever knob sub–assy (m/t transaxle) 2. Remove console panel upper 3. Remove heater control knob 4. Remove instrument cluster finish panel 5. Remove instrument cluster finish panel sub–assy center
Toyota Corolla. Remove instrument cluster finish panel sub–assy center
  1. Remove the 4 screws.
  2. using a screwdriver, disengage the 2 clips and 4 claws, then remove the instrument cluster finish panel sub–assy center with radio receiver assy. Hint

    : tape the screwdriver tip before use.

  3. disconnect the connectors.
6. Remove radio receiver assy
Toyota Corolla. Remove radio receiver assy
  1. Disengage the 4 claws and 6 pins.
  2. remove the radio receiver assy from the instrument cluster finish panel sub–assy center.
7. Remove radio bracket no.1
Toyota Corolla. Remove radio bracket no.1
  1. Remove the 4 screws and radio bracket no. 1.
8. Remove radio bracket no.2
Toyota Corolla. Remove radio bracket no.2
  1. remove the 4 screws and radio bracket no. 2.
9. Install instrument cluster finish panel sub–assy center
Toyota Corolla. Install instrument cluster finish panel sub–assy center
  1. Place the radio receiver assy temporarily on the instrument panel sub–assy upper. (*1)
  2. under the condition of (*1), engage the 6 pins and 4 claws of the radio receiver assy with the instrument cluster finish panel sub–assy center. (*2)
  3. under the condition of (*2), slide the instrument cluster finish panel sub–assy center and the radio receiver assy forward of the vehicle.
    Toyota Corolla. Install instrument cluster finish panel sub–assy center
  4. Connect the connectors and install the 2 clips and 4 claws.
  5. install the 4 screws and instrument cluster finish panel sub–assy center with radio receiver assy.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.