Toyota Corolla Quiz
Brake

Replacement

In this manual: Brake
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
9steps
~54min
2/5difficulty
Done 0 of 9
1. Remove console box sub–assy rear 2. Remove parking brake lever sub–assy
Toyota Corolla. Remove parking brake lever sub–assy
  1. Disconnect the parking brake switch connector from the parking brake switch.
  2. remove the lock nut and adjusting nut from the parking brake cable assy no.1.
    Toyota Corolla. Remove parking brake lever sub–assy
  3. Remove the 2 bolts.
    Toyota Corolla. Remove parking brake lever sub–assy
  4. Using a screwdriver, raise the pick on the parking brake lever, and remove the parking brake cable assy no.1 From the parking brake lever.
  5. remove the parking brake lever from the body.
3. Remove parking brake switch assy
Toyota Corolla. Remove parking brake switch assy
  1. Remove the screw and parking brake switch assy.
4. Install parking brake switch assy
Toyota Corolla. Install parking brake switch assy
  1. Install the parking brake switch to the parking brake lever sub–assy with the screw.
5. Install parking brake lever sub–assy
Toyota Corolla. Install parking brake lever sub–assy
  1. Install the parking brake cable assy no.1 To the parking brake lever, temporarily tighten the adjusting nut and lock nut.
  2. using a screwdriver, fix the parking brake cable no.1 To the pick.
    Toyota Corolla. Install parking brake lever sub–assy
  3. Install the parking brake lever with the 2 bolts.

    Torque: 12.5 Nvm (130 Kgf·cm, 9 ft·lbf)

    Toyota Corolla. Install parking brake lever sub–assy
  4. Connect the parking brake switch connector to the parking brake switch.
6. Inspect parking brake lever travel 7. Adjust parking brake lever travel 8. Install console box sub–assy rear

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.