Toyota Corolla Quiz
Brake

Replacement

In this manual: Brake
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
6steps
~36min
2/5difficulty
Done 0 of 6
Hint

: for parking brake cable assy no.2, Perform the same procedure to the parking brake cable assy no.3

. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Remove rear brake automatic adjust lever lh 4. Remove front brake shoe

sst 09718–00010

5. Remove parking brake shoe strut set lh 6. Remove rear brake shoe

sst 09718–00010

7. Disconnect parking brake cable assy no.3
Toyota Corolla. Disconnect parking brake cable assy no.3
  1. Remove the bolt, and disconnect the parking brake cable assy no.3 From the backing plate.
8. Remove exhaust pipe assy front 9. Remove front floor heat insulator no.1 10. Remove front floor heat insulator no.2 11. Remove fuel tank protector no.1
  1. remove the 5 nuts and fuel tank protector no.1.
12. Remove parking brake cable assy no.3
Toyota Corolla. Remove parking brake cable assy no.3
  1. Using a clip remover, disconnect the skid control sensor wire harness clip from the clamp.
  2. remove the 4 bolts and cable retainer from the body.
  3. disconnect the parking brake cable assy no.3 From the equalizer, and remove the parking brake cable assy no.3.
13. Install parking brake cable assy no.3
  1. connect the parking brake cable assy no.3 To the equalizer.
  2. Install the parking brake cable assy no.3 With the 4 bolts and cable retainer.

    Torque: 5.4 Nvm (55 Kgf·cm, 48 in.Vlbf)

    Toyota Corolla. Install parking brake cable assy no.3
  3. Connect the skid control sensor wire harness clip to the clamp.
14. Install fuel tank protector no.1
Toyota Corolla. Install fuel tank protector no.1
  1. install the fuel tank protector no.1 With the 5 nuts.

    Torque: 5.5 Nvm (55 Kgf·cm, 48 in.Vlbf)

15. Install front floor heat insulator no.2 16. Install front floor heat insulator no.1 17. Install exhaust pipe assy front 18. Connect parking brake cable assy no.3
Toyota Corolla. Connect parking brake cable assy no.3
  1. Connect the parking brake cable assy no.3 To the backing plate with the bolt.

    Torque: 7.8 Nvm (80 Kgf·cm, 69 in.Vlbf)

19. Application high temperature grease 20. Install rear brake shoe

sst 09718–00010

21. Install parking brake shoe strut set lh 22. Install front brake shoe

sst 09718–00010

23. Install rear brake automatic adjust lever lh 24. Check rear drum brake installation 25. Install rear brake drum sub–assy 26. Adjust rear drum brake shoe clearance 27. Install rear wheel

torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)

28. Inspect parking brake lever travel 29. Adjust parking brake lever travel 30. Check exhaust leakage

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.