Brake

Speed sensor rear LH (4WD)

~1min read

REPLACEMENT

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

1. REMOVE DECK TRIM SIDE PANEL ASSY LH (SEE PAGE 76-21 )

2. REMOVE REAR WHEEL

3. REMOVE SPEED SENSOR REAR LH

REMOVE SPEED SENSOR REAR LH

(a) Disconnect the speed sensor connector.

NOTICE: Be careful not to damage the wire harness.

REMOVE SPEED SENSOR REAR LH

(b) Pull out the sensor wire harness with the grommet.

NOTICE: Do not pull sensor wire.

(c) Remove the 2 bolts holding the sensor harness from the body and the shock absorber assy.

REMOVE SPEED SENSOR REAR LH

(d) Remove the bolt and the speed sensor rear.

NOTICE: Prevent foreign matter from attaching to the sensor tip.

4. INSTALL SPEED SENSOR REAR LH

INSTALL SPEED SENSOR REAR LH

(a) Install the speed sensor rear with the bolt.

Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf)

NOTICE: Prevent foreign matter from attaching to the sensor tip.

INSTALL SPEED SENSOR REAR LH

(b) Install the sensor harness clamps with the 2 bolts to the body and the shock absorber assy.

Torque: 5.0 NVm (51 kgfVcm, 44 in.Vlbf)

NOTICE: Do not twist the sensor wire when installing the sensor.

(c) Push in the sensor wire harness with grommet.

NOTICE: When grommet is set to body, pull the grommet. Do not pull sensor wire.

INSTALL SPEED SENSOR REAR LH

(d) Connect the speed sensor connector.

5. INSTALL REAR WHEEL

Torque: 103 NVm (1,050 kgfVcm, 76 ftVlbf)

6. INSTALL DECK TRIM SIDE PANEL ASSY LH

7. CHECK ABS SPEED SENSOR SIGNAL (SEE PAGE 05-765 )