Checking and replacing fuses

If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary.

Turn the “ENGINE START STOP” switch OFF.

Open the fuse box cover.

• Engine compartment (fuse box on the left side)

Push the tab in and lift the lid off.

• Engine compartment (fuse box on the right side)

Push the tabs in and lift the lid off.

• Driver’s side instrument panel

Remove the lid.

• Passenger’s side instrument panel

Remove the cover.

Remove the lid.

After a system failure, see “Fuse layout and amperage ratings” for details about which fuse to check.

Remove the fuse with the pullout tool.

Check if the fuse has blown.

• Type A and B

1. 1
   Normal fuse
2. 2
   Blown fuse

Replace it with one of an appropriate amperage rating.

The amperage rating can be found on the fuse box lid.

• Type C and D

1. 1
   Normal fuse
2. 2
   Blown fuse

Contact your Toyota dealer.

• Engine compartment (fuse box on the left side)

• Engine compartment (fuse box on the right side)

• Driver’s side instrument panel

• Passenger’s side instrument panel

• After a fuse is replaced

• If the lights do not turn on even after the fuse has been replaced, a bulb may need replacement.
• If the replaced fuse blows again, have the vehicle inspected by your Toyota dealer.

• If there is an overload in the circuits

The fuses are designed to blow, protecting the wiring harness from damage.

• To prevent system breakdowns and vehicle fire

Observe the following precautions.

Failing to do so may cause damage to the vehicle, and possibly a fire or injury.

• Never use a fuse of a higher amperage rating than indicated, or use any other object in place of a fuse.
• Always use a genuine Toyota fuse or equivalent.

  Never replace a fuse with a wire, even as a temporary fix.

• Do not modify fuses or the fuse box.

• Before replacing fuses

Have the cause of electrical overload determined and repaired by your Toyota dealer.