Toyota Land Cruiser Quiz
Steering

Reassembly

In this manual: Steering
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read
010203040502216N·mlb·ft
Tightening torque found on this page

1. COAT WITH POWER STEERING FLUID ( SR-38 )

2. INSTALL VANE PUMP SHAFT

3. INSTALL SIDE PLATE

INSTALL SIDE PLATE
(a) Install a new O-ring to the front housing. (b) Install a new O-ring to side plate.

(c) Install the side plate as shown in the illustrating.

HINT: Align the hole of the side plate with the hole of the front housing.

4. INSTALL CAM RING

INSTALL CAM RING

Install the ring with the inscribed mark facing outward.

HINT: Align the hole of the cam ring with the hole of the front housing.

5. INSTALL VANE PUMP ROTOR

(a) Install the rotor with the inscribed mark facing outward.

(b) Install a new snap ring to the vane pump shaft.

6. INSTALL 10 VANE PLATES

(a) Install the plates with the round end facing outward.

7. INSTALL REAR HOUSING

(a) Coat new gasket with power steering fluid and install it to the housing. (b) Temporarily install the 4 bolts. (c) Using SST, hold the vane pump assembly in a vise.

(d) Torque the 4 bolts.

Torque: 22 N·m

8. INSTALL SPRING, FLOW CONTROL VALVE AND PRESSURE PORT UNION

(a) Install the valve facing the correct direction ( SR-38 ). (b) Coat a new O-ring with power steering fluid and install it to the union.

(c) Torque the union.

Torque: 69 N·m

9. INSTALL SUCTION PORT UNION

(a) Coat a new O-ring with power steering fluid and install it to the union.

(b) Torque the bolt.

Torque: 12 N·m

10. MEASURE PS VANE PUMP ROTATING TORQUE ( SR-41 )

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.