2Az-fe charging

Cooling fan relay

15steps
~90min
4/5difficulty
Done 0 of 15
On-vehicle inspection
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove engine room no. 2 Relay block cover
  2. Inspect no. 1 Fan relay (marking: fan no. 1)
  3. Remove the relay from the engine room no. 2 Relay block.
  4. measure the resistance of the relay.
Standard resistance
Toyota RAV4. Inspect no. 1 Fan relay (marking: fan no. 1)

If the result is not as specified, replace the relay.

  1. Install the relay.
  2. Inspect no. 2 Fan relay (marking: fan no. 2)
    Toyota RAV4. Inspect no. 2 Fan relay (marking: fan no. 2)

  1. Remove the relay from the engine room no. 2 Relay block.
  2. Measure the resistance of the relay.
Standard resistance

If the result is not as specified, replace the relay.

  1. Install the relay.
  2. Inspect no. 3 Fan relay (marking: fan no. 3)
    Toyota RAV4. Inspect no. 3 Fan relay (marking: fan no. 3)

  1. Remove the relay from the engine room no. 2 Relay block.
  2. Measure the resistance of the relay.
Standard resistance

If the result is not as specified, replace the relay.

  1. Install the relay.
  2. Install engine room no. 2 Relay block cover
  3. Connect cable to negative battery terminal

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.