Differential
Differential oil
In this manual: Differential
2steps
~12min
1/5difficulty
Done 0 of 2
On-vehicle inspection

- Check differential oil

- Stop the vehicle on a level surface.
- Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.

- Check that the oil level is between 0 to 5 mm (0 to 0.20 In.) From the bottom lip of the differential filler plug hole.
- After changing the oil seal, drive the vehicle and then check the oil level again.
- Too much or too little oil will lead to differential problems.
If necessary, fill the differential carrier assembly with hypoid gear oil.
Recommended viscosity: sae 90 Standard oil grade: hypoid gear oil sx api gl-5 Standard differential oil capacity: 0.45 To 0.55 Liters (0.48 To 0.58 Us qts., 0.40 To 0.48 Imp. Qts.)- Using a 10 mm socket hexagon wrench, install a new gasket and the rear differential filler plug.
Torque: 39 n*m (398 kgf*cm, 29 ft.*Lbf)
Test yourself
A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?