Disassembly (2005/11-2006/01)

1. Remove front axle inboard joint boot no. 2 Clamp lh

1. 1
   One touch type:
2. 2
   Using a screwdriver, remove the no. 2 Inboard joint boot clamp, as shown in the illustration.
3. 3
   Claw engagement type:

Using needle-nose pliers, remove the no. 2 Inboard joint boot clamp, as shown in the illustration.

2. Remove front axle inboard joint boot no.

Using needle-nose pliers, remove the no. 2 Inboard joint boot clamp, as shown in the illustration.

3. Remove front axle inboard joint boot clamp lh

1. 1
   One touch type:
2. 2
   Using a screwdriver, remove the inboard joint boot clamp, as shown in the illustration.
3. 3
   Claw engagement type:

Using needle-nose pliers, remove the inboard joint boot clamp, as shown in the illustration.

4. Remove front axle inboard joint boot clamp rh

Use the same procedures described for the lh side.

1. 1
   Remove front axle inboard joint boot
2. 2
   Remove the boot from the inboard joint.
3. 3
   Remove front drive inboard joint assembly lh

   

1. 1
   Remove any old grease from the inboard joint.
2. 2
   Put matchmarks on the inboard joint and outboard joint shaft.

Do not punch the marks.

3. Remove the inboard joint from the outboard joint shaft.

4. Using a snap ring expander, remove the shaft snap ring.

5. Put matchmarks on the outboard joint shaft and tripod joint.

Do not punch the marks.

6. Using a brass bar and hammer, tap out the tripod joint from the outboard joint shaft.

Do not tap the rollers.

1. 1
   Remove the inboard joint boot.
2. 2
   Remove front drive shaft damper clamp lh

   

1. 1
   One touch type:
2. 2
   Using a screwdriver, remove the drive shaft damper clamp, as shown in the illustration.
3. 3
   Claw engagement type:
4. 4
   Using needle-nose pliers, remove the drive shaft damper clamp, as shown in the illustration.
5. 5
   Remove front drive shaft damper lh
6. 6
   Remove the front drive shaft damper.
7. 7
   Remove front drive shaft damper clamp rh

Use the same procedures described for the lh side.

10. Remove front drive shaft damper rh

Use the same procedures described for the lh side.

11. Remove front axle outboard joint boot no. 2 Clamp lh

1. 1
   Using a screwdriver, remove the no. 2 Outboard joint boot clamp, as shown in the illustration.
2. 2
   Remove front axle outboard joint boot clamp lh

   

1. 1
   Using a screwdriver, remove the outboard joint boot clamp, as shown in the illustration.
2. 2
   Remove front axle outboard joint boot
3. 3
   Remove the outboard joint boot from the outboard joint shaft.
4. 4
   Remove any old grease from the outboard joint.
5. 5
   Remove front drive shaft hole snap ring lh

   

1. 1
   Using a screwdriver, remove the hole snap ring.
2. 2
   Remove front drive shaft dust cover lh

   

1. Using sst and a press, press out the front drive shaft dust cover.

Be careful not to drop the inboard joint

1. 1
   Remove front drive shaft dust cover rh
2. 2
   Using a press, press out the drive shaft dust cover.
3. 3
   Remove front drive shaft bearing
4. 4
   Using a snap ring expander, remove the drive shaft hole snap ring.

   

2. Using sst and a press, press out the drive shaft bearing.

3. Remove the snap ring.