Dtc check / clear

1. Check dtc

1. 1
   When using intelligent tester:
2. 2
   Connect the intelligent tester (with can vim) to the dlc3.
3. 3
   Turn the ignition switch on and press the intelligent tester main switch on.
4. 4
   Read the dtcs by following the prompts on the intelligent tester.

Hint:

Refer to the intelligent tester operator's manual for further details.

1. 1
   When not using intelligent tester:
2. 2
   Using sst, connect terminals 13 (tc) and 4 (cg) of the dlc3.

Sst 09843-18040

Turn the ignition switch on.

Read and write down any dtcs indicated by the p/s warning light on the combination meter.

Refer to the chart below for examples of a normal code and dtcs 21 and 22.

Hint:

• If the p/s warning light does not blink to display any dtcs set or the normal code, inspect the circuit shown in the table below.


• If two or more malfunctions are detected simultaneously, dtcs will be displayed in ascending numerical order.

1. 1
   Refer to the diagnostic trouble code chart (see page ps-16) for dtc information.
2. 2
   Clear dtc
3. 3
   When using intelligent tester:
4. 4
   Connect the intelligent tester (with can vim) to the dlc3.
5. 5
   Turn the ignition switch on and press the intelligent tester main switch on.
6. 6
   Clear the dtcs by following the prompts on the intelligent tester.
7. 7
   Turn the ignition switch off.
8. 8
   Disconnect the intelligent tester from the dlc3.
9. 9
   When not using intelligent tester:

   

1. Using sst, connect terminals 12 (ts) and 4 (cg) of the dlc3.

Sst 09843-18040

Turn the ignition switch on.

Disconnect the sst check wire from terminal 4 (cg) and reconnect it, and repeat this procedure 4 times or more within 8 seconds.

Check that the p/s warning light blinking pattern is the normal code.

Turn the ignition switch off.

Remove sst from the dlc3.