Toyota RAV4 Quiz
2Az-fe engine mechanical

Ig1 relay

In this manual: 2Az-fe engine mechanical
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
6steps
~36min
2/5difficulty
Done 0 of 6
On-vehicle inspection
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove ig1 relay
  2. Remove the ig1 relay from the instrument panel junction block.
  3. Inspect relay
  4. Measure resistance of the ig1 relay.
Standard resistance

If the result is not as specified, replace the relay.

  1. Install ig1 relay
  2. Connect cable to negative battery terminal
    Toyota RAV4. Ig1 relay

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.