Installation

Hint:

• Use the same procedures for the rh side and lh side.
• The procedures listed below are for the lh side.

1. Install no. 2 Seat leg box protector

1. 1
   Attach the clip to install the protector.
2. 2
   Install the clip.
3. 3
   Install rear no. 1 Floor mat support side plate
4. 4
   Install rear no. 2 Seat assembly
5. 5
   Fully tilt the seatback forward.

   

1. 1
   Place the seat onto the lock striker.
2. 2
   Fully lock the seat to the lock striker.

Hint:

• Lock the rear side, then lock the front side.
• Confirm that the seat is firmly locked to the lock striker.

4. Install the rear no. 2 Seat link with the 2 nuts.

Torque: 18 n*m (184 kgf*cm, 13 ft.*Lbf)

5. Install the seat to the rear no. 2 Seat link with the 2 bolts.

Torque: 18 n*m (184 kgf*cm, 13 ft.*Lbf)

6. Pass the rear seat cushion wire underneath the rear no. 2 Seat link part labeled a.

Notice:

If the wire is not installed as described, the seat will not move properly.

1. 1
   Install the rear seat cushion wire to the rear no. 2 Seat link with the nut.
2. 2
   Install no. 2 Seat leg cover lh

   

Torque: 18 n*m (184 kgf*cm, 13 ft.*Lbf)

1. 1
   Attach the 5 claws to install the leg cover.
2. 2
   Install no. 2 Seat hinge cover lh

   

1. Push the hinge cover in the direction indicated by the arrow in the illustration to attach the 2 claws.

1. 1
   Attach the 2 claws and clip to install the hinge cover.
2. 2
   Return the seatback to the upright position.