Toyota RAV4 Quiz
Supplemental restraint system

Installation

In this manual: Supplemental restraint system
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
9steps
~54min
2/5difficulty
Done 0 of 9
Caution: Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
  1. Install front passenger airbag assembly
  2. Attach the rear side hook of the front passenger airbag to the rear side airbag door.
  3. Bend the front side hook so that it attaches to the front side airbag door.
  4. Install the instrument panel upper (see page ip-9).
  5. Install the 2 bolts to the reinforcement.
Torque: 20 n*m (203 kgf*cm, 14 ft.*Lbf)
  • Connect the connector to the airbag.
    • Notice:

    When handling the airbag connector, do not damage the airbag wire harness.

    1. Attach the wire harness clamp to the bracket.
    Toyota RAV4. Install front passenger airbag assembly

    1. Install glove compartment door assembly (see page ip-9)
    2. Connect cable to negative battery terminal
    3. Check srs warning light
    4. Check the srs warning light (see page rs-34).

    Test yourself

    A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.