Door lock
Only passenger door lock / unlock functions do not operate
In this manual: Door lock
6steps
~36min
2/5difficulty
Done 0 of 6
Description

Inspection procedure
Ok: when the door lock is operating, the intelligent tester should display as shown in the table.







Replace instrument panel junction block (main body ecu)
The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly.
Wiring diagram
Inspection procedure
- Read value of intelligent tester (lock position switch)
- Use the data list to check if the door lock is functioning properly.

Ok: when the door lock is operating, the intelligent tester should display as shown in the table.

- Inspect front door with motor lock assembly rh

- Apply the battery voltage to the door lock motor and check the operation of the door lock motor.
- Measure the resistance of the door lock position switch.


- Check wire harness (door lock - ecu)

- Disconnect the g5 door lock connector.
- Disconnect the e15 ecu connector.
- Disconnect the ih junction block connector.
- Measure the resistance of the wire harness side connectors.


Replace instrument panel junction block (main body ecu)
Test yourself
A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?