All doors cannot be locked / unlocked simultaneously

The main body ecu receives switch signals from the door control switch on the power window regulator master switch, door control switch and driver side door key cylinder, and activates the door lock motor on each door accordingly.

1. 1
   Perform active test by intelligent tester (door lock)
2. 2
   Select the active test, use the intelligent tester to generate a control command, and then check that the doors lock / unlock.

   

1. 1
   Inspect fuse (ecu-b)
2. 2
   Remove the ecu-b fuse from the engine room no. 2 Relay block.
3. 3
   Measure the resistance.

Standard resistance: below 1

3. Check wire harness (ecu - battery and body ground)

1. 1
   Disconnect the ih and ie junction block connectors.
2. 2
   Measure the voltage of the wire harness side connector.

Standard voltage

3. Measure the resistance of the wire harness side connector.

Standard resistance

1. 1
   Inspect all doors lock / unlock operation
2. 2
   All doors can be locked/unlocked at once using the following:

• Door control switch on the master switch (switch operation)
• Door control switch on the front passenger side (switch operation).
• Door key cylinder linked with door lock on the driver side (key operation)

2. Proceed to the next step according to the symptom if all the doors cannot be locked / unlocked at once.

1. 1
   Inspect driver side door lock / unlock operation
2. 2
   Proceed to the next step according to the symptom listed in the table below.

   

1. 1
   Read value of intelligent tester (door control switch on master switch)
2. 2
   Use the data list to check if the door control switch is functioning properly.

   

7. Inspect power window regulator master switch assembly (door control switch)

1. 1
   Remove the master switch.
2. 2
   Measure the resistance of the door control switch.

Standard resistance

8. Check wire harness (master switch - ecu and body ground)

1. 1
   Disconnect the h2 master switch connector.
2. 2
   Disconnect the ih junction block connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance

1. 1
   Read value of intelligent tester (door key switch)
2. 2
   Use the data list to check if the door key is functioning properly.

   

1. 1
   Inspect front door with motor lock assembly lh

   

2. 2
   Remove the front door lock.
3. 3
   Measure the resistance of the door lock and unlock switch.

Standard resistance

11. Check wire harness (motor - ecu and body ground)

1. 1
   disconnect the h5 door lock motor connector.
2. 2
   Disconnect the e15 ecu connector.
3. 3
   Disconnect the ih junction block connector.
4. 4
   Measure the resistance of the wire harness side connectors.

Standard resistance

12. Inspect door control switch assembly

1. 1
   Remove the control switch.
2. 2
   Measure the resistance of the door control switch.

Standard resistance

13. Check wire harness (switch - ecu and body ground)

1. 1
   Disconnect the g6 switch connector.
2. 2
   Disconnect the ih junction block connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance