Toyota RAV4 Quiz
Axle

Rear axle hub bolt

In this manual: Axle
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
9steps
~59min
3/5difficulty
1special tools
Done 0 of 9
Components
Toyota RAV4. Rear axle hub bolt

Replacement Hint:
  • Use the same procedures for the rh side and lh side.
  • The procedures listed below are for the lh side.
  1. Remove rear wheel
  2. Remove rear disc brake cylinder assembly lh (see page br-55)
  3. Remove rear disc (see page br-57)
  4. Remove rear axle hub bolt
    Toyota RAV4. Remove rear axle hub bolt

  1. Using sst and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.
Sst 09650-17011
  1. Install rear axle hub bolt
Toyota RAV4. Install rear axle hub bolt

  1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
  2. Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer
  3. Install rear disc (see page br-58)
  4. Install rear disc brake cylinder assembly lh (see page br-61)
  5. Install rear wheel torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.