Tire and wheel
Transmitter id not registered in main mode
In this manual: Tire and wheel
7steps
~42min
2/5difficulty
Done 0 of 7

Description

Inspection procedure Notice:
It is necessary to register an id code after replacing the tire pressure warning valve and transmitter and/or the tire pressure monitor ecu (see page tw-9).
Hint:Set the tire pressure to the specified value.
Standard pressure: 220 kpa (2.2 Kgf/cm2, 32 psi)- Read value of intelligent tester (registered id codes)
- Check the data list for proper functioning of the registered id codes.

Ok: the registered transmitter id codes are displayed on the intelligent tester screen.

- Perform registration (transmitter id)
- Register the transmitter ids for all the wheels (see page tw-9).
- Set the pressure of each tire to the specified value.

- Read value of intelligent tester (tire pressure)
- Check the data list tire pressure value.

Ok: all tire pressure readings are equal to the actual tire pressure. Notice:
It may take up to 1 minute to display the tire pressure data.

End
Test yourself
A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?