Diagnosis system

1. Check dlc3

The ecm uses iso 15765-4 for communication. The terminal arrangement of the dlc3 complies with sae j1962 and matches the iso 15765-4 format.

If the result is not as specified, the dlc3 may have a malfunction. Repair or replace the harness and connector.

Connect the cable of the intelligent tester (with can vim) to the dlc3, turn the ignition switch on and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem wither with the vehicle or with the tester.

• If communication is normal when the tester is connected to another vehicle, inspect the dlc3 on the original vehicle
• If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tester itself. So consult the service department listed in the tester's instruction manual.

1. 1
   Diagnosis system
2. 2
   Warning light

   

1. The tire pressure warning light blinks when there is a malfunction in the tire pressure warning system.

When the malfunction has been corrected, the tire pressure warning light does not turn on.

1. 1
   Dtcs (normal mode)
2. 2
   Dtcs are memorized in the tire pressure warning ecu. These dtcs can be read by checking the blinks of the tire pressure warning light or by using the intelligent tester (see page tw-20).
3. 3
   Test mode
4. 4
   By switching from normal mode to test mode (input signal check), you can inspect the tire pressure monitor receiver, each tire pressure warning valve and transmitter and vehicle speed sensor (see page tw-12).
5. 5
   Check tire pressure warning light

   

1. 1
   Turn the ignition switch on.
2. 2
   Check that the tire pressure warning light turns on for 3 seconds.

4. Tire pressure warning light chart

The table below indicates the state of the tire pressure warning light after the ignition switch is turned on.

*1: Turns on and turns off repeatedly at 0.5 Second intervals.

*2: Turns on and turns off repeatedly at 0.125 Second intervals.

*3: Turns on and turns off repeatedly at 0.25 Second intervals.

1. Dtc check (using intelligent tester)

1. 1
   Connect the intelligent tester (with can vim) to the dlc3.
2. 2
   Turn the ignition switch on.
3. 3
   Read the dtcs following the prompts on the tester screen.

Refer to the intelligent tester operator's manual for further details.

2. Check dtc (using sst check wire)

1. Using sst, connect terminals 13 (tc) and 4 (cg) of the dlc3.

2. Turn the ignition switch on.

3. Read and record any dtcs from the tire pressure warning light on the combination meter. Refer to the illustration for examples of a normal system code and dtcs 13 and 33.

• If the tire pressure warning light does not blink to indicate any dtcs or the normal system code, inspect the tire pressure warning light circuit or 13 (tc) and 4 (cg) terminal circuits.


• If 2 or more malfunctions are indicated at the same time, the lowest numbered dtc is displayed first.

1. 1
   Refer to the diagnostic trouble code chart for dtc information (see page tw-22).
2. 2
   After completing the check, turn the ignition switch off and remove sst from the dlc3.
3. 3
   Clear dtc (using intelligent tester)

   

After repairing the malfunctions, clear the dtcs.

1. 1
   Connect the intelligent tester (with can vim) to the dlc3.
2. 2
   Turn the ignition switch on.
3. 3
   Erase the dtcs following the prompts on the tester screen.

Refer to the intelligent tester operator's manual for further details.