Adjustment

HINT: On the RH side, use the same procedures as on the LH side.

1. INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH

1. Check that the clearance is within the standard range.

Standard

2. ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH

1. 1
   Using the SST, horizontally and vertically adjust the door by loosening the hinge center bolts.

   SST 09812-00010, 09812-00020

2. 2
   Tighten the hinge assembly center bolts after the adjustment.

   Torque: 31 N*m (306 kgf*cm, 23 ft.*lbf)

   

3. 3
   Vertically adjust the front side of the door by loosening the roller lower bolts.
4. 4
   Tighten the roller lower bolts after the adjustment.

   Torque: 31 N*m (306 kgf*cm, 23 ft.*lbf)

   

5. 5
   Horizontally adjust the front lower side of the door by loosening the roller lower bolts.
6. 6
   Tighten the roller lower bolts after the adjustment.

   Torque: 31 N*m (306 kgf*cm, 23 ft.*lbf)

   

7. 7
   Horizontally adjust the front upper side of the door by loosening the roller upper bolts.
8. 8
   Tighten the roller assembly lower bolts after the adjustment.

   Torque: 8.5 N*m (82 kgf*cm, 73 in.*lbf)

   

9. 9
   Adjust the position of the door lock striker by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
10. 10
    Tighten the striker mounting screws after the adjustment.

    Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)

    

11. 11
    Adjust the position of the front lock striker by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
12. 12
    Tighten the striker mounting screws after the adjustment.

    Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)

13. 13
    Adjust the position of the down stopper by moving the male stopper, so that the male stopper can enter smoothly.
14. 14
    Tighten the female stopper mounting bolts after the adjustment.

    Torque: 5.5 N*m (58 kgf*cm, 49 in.*lbf)