Toyota Sienna Quiz
Engine hood / door

Reassembly

In this manual: Engine hood / door
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
14steps
~84min
3/5difficulty
Done 0 of 14

1. INSTALL REAR DOOR WIRE SUB-ASSEMBLY LH

INSTALL REAR DOOR WIRE SUB-ASSEMBLY LH
  1. Install the wire.

    NOTICE: When installing the wire, push the areas where the clips are installed in order to prevent damage and deformation.

  2. Install the 2 screws.

2. INSTALL REAR DOOR LOCK ASSEMBLY LH

INSTALL REAR DOOR LOCK ASSEMBLY LH
  1. Apply MP grease to the sliding and rotating areas of the lock.
  2. Apply adhesive to the threads of the screws.

    Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent

  3. Install the lock to the door panel with the 3 screws.

    Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

  4. Connect the cable.

3. INSTALL SLIDE DOOR LOCK ASSEMBLY FRONT LH

INSTALL SLIDE DOOR LOCK ASSEMBLY FRONT LH
  1. Apply MP grease to the sliding and rotating areas of the lock.
  2. Apply adhesive to the threads of the screws.

    Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent

  3. Install the lock front to the door panel with the 3 screws.

    Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

  4. Connect the 2 cables.
    INSTALL SLIDE DOOR LOCK ASSEMBLY FRONT LH

4. INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH

  1. Apply MP grease to the sliding and rotating parts of the outside handle frame.
  2. Slide the outside handle frame in the direction indicated by the arrow mark in the illustration.
  3. Using a torx socket wrench (T30), install the outside handle frame with the screw.

    Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf) NOTICE: Insert a cover between the nut and the door panel.

  4. Install the open rod.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.