Toyota Sienna Quiz
Engine hood / door

Data list / active test

In this manual: Engine hood / door
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
6steps
~36min
2/5difficulty
Done 0 of 6

1. DATA LIST

HINT: Using the DATA LIST displayed on the intelligent tester, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

  1. Connect the intelligent tester to the DLC3.
  2. Turn the ignition switch ON.
  3. Read the DATA LIST according to the display on the tester.

Power slide door ECU LH/RH:

Power slide door ECU LH/RH
Power slide door ECU LH/RH

*1 "POLE" appears on the display of the intelligent tester, however the name of the part corresponding to the display of the tester is "pawl".

*2 "0.0s" appearing on the display of the intelligent tester means that a 1-press of the satellite switch operates the power slide door.

*3 "B PILLAR SW" appears on the display of the intelligent tester, however the name of the part corresponding to the display of the tester is "Power slide door control switch".

*4 Power slide door ECU LH only.

*5 In case that the "CAUTION" is displayed even without resistance applied in each range, there must be a foreign object caught somewhere in that range.

2. ACTIVE TEST

HINT: Performing the ACTIVE TEST using the intelligent tester allows you to operate the relay, VSV, actuator, etc.

without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten the labor time. It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.
  2. Turn the ignition switch ON.
  3. Perform the ACTIVE TEST according to the display on the tester.

Power Slide Door ECU LH/RH

Power Slide Door ECU LH/RH

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.