Toyota Sienna Quiz
Lighting

Hazard warning switch

In this manual: Lighting
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

INSPECTION

1. HAZARD WARNING SIGNAL SWITCH ASSEMBLY

HAZARD WARNING SIGNAL SWITCH ASSEMBLY
  1. Check that there is resistance between the terminals at each switch position as shown in the chart.

Resistance

Resistance
  1. Inspect illumination operation.
  2. Connect the positive (+) lead from the battery to the terminal 6 and negative (-) lead to the terminal 5, then check that the illumination comes on.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.