Toyota Sienna Quiz
Lighting

Rear combination light assembly

In this manual: Lighting
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
9steps
~54min
2/5difficulty
Done 0 of 9

COMPONENTS

COMPONENTS

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR COMBINATION LIGHT ASSEMBLY

REMOVE REAR COMBINATION LIGHT ASSEMBLY
  1. Remove the 2 bolts.
  2. Disengage the 2 pins and separate the rear combination light assembly as shown in the illustration.
  3. Disconnect the connector and remove the rear combination light assembly.

DISASSEMBLY

1. REMOVE REAR COMBINATION LIGHT BULB

REMOVE REAR COMBINATION LIGHT BULB
  1. Turn in the direction indicated by the arrow and separate the 2 rear combination light bulbs.
  2. Remove the 2 rear combination light bulbs from the rear combination light socket and wire subassembly.

REASSEMBLY

1. INSTALL REAR COMBINATION LIGHT BULB

INSTALL REAR COMBINATION LIGHT BULB
  1. Install the 2 rear combination light bulbs to the rear combination light socket and wire sub-assembly.
  2. Turn in the direction indicated by the arrow and install the 2 rear combination light bulbs to the rear combination light assembly.

INSTALLATION

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

INSTALL REAR COMBINATION LIGHT ASSEMBLY
  1. Connect the connector.
  2. Install the rear combination light assembly with the 2 bolts and 2 pins as shown in the illustration.

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.