Toyota Sienna Quiz
Brake control

Inspection

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. INSPECT REAR SPEED SENSOR

INSPECT REAR SPEED SENSOR

(a) Remove the seat cushion and seatback.

(b) Disconnect the speed sensor connector.

(c) Measure the resistance between terminals 1 and 2 of the speed sensor connector

OK: Resistance: 1.1 +- 0.2 kΩ at 25 +- 5 °C

(d) Measure the resistance between each of terminals 1 and 2 of skid control sensor connector and body ground.

OK: Resistance: 1 MΩ or higher

NOTICE: Check the speed sensor signal last (See page BC-10).

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.