Toyota Sienna Quiz
Brake control

Installation

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

HINT: Install the RH side by same procedure as the LH side.

1. INSTALL REAR SPEED SENSOR

INSTALL REAR SPEED SENSOR

(a) Install the speed sensor rear LH with the bolt.

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE: Keep the tip of the speed sensor rear LH clean.

INSTALL REAR SPEED SENSOR

(b) Install the sensor harness clamps with the bolts to the body.

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) (c) Push in the sensor wire harness with grommet.

NOTICE: When grommet i set to body, pull the grommet, and don't pull the sensor wire.

INSTALL REAR SPEED SENSOR

(d) Connect the speed sensor connector.

2. INSTALL QUARTER TRIM PANEL ASSEMBLY LH

3. INSTALL REAR WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

4. CHECK ABS SPEED SENSOR SIGNAL

HINT: See page BC-10.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.