Toyota Sienna Quiz
Brake control

Removal

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

HINT: Remove the RH side by the same procedure as the LH side.

1. REMOVE REAR WHEEL

2. REMOVE QUARTER TRIM PANEL ASSEMBLY FRONT LH

HINT: Remove the LH side by the same procedure as the RH side (See page IR-9).

3. REMOVE REAR SPEED SENSOR

REMOVE REAR SPEED SENSOR

(a) Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.

REMOVE REAR SPEED SENSOR

(b) Remove the clamp bolt holding the sensor harness from the body.

REMOVE REAR SPEED SENSOR

(c) Remove the bolt and speed sensor rear LH.

NOTICE: Keep the tip of the speed sensor rear LH clean.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.