Installation

1. INSTALL STABILIZER BAR FRONT

2. INSTALL FRONT STABILIZER BAR BUSH NO.1

(a) Install the front stabilizer bar bush No. 1.

HINT: Install the bushing to the outer side of the bushing stopper on the stabilizer bar as shown in the illustration.

4. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY

HINT: (See page PS-21)

5. CONNECT PRESSURE FEED TUBE ASSEMBLY

HINT: (See page PS-21) SST 09023-12701

6. INSTALL TIE ROD ASSEMBLY LH

HINT: (See page AH-4)

7. INSTALL TIE ROD ASSEMBLY RH

HINT: Install the RH side by the same procedures as the LH side.

8. INSTALL FRONT STABILIZER BRACKET NO.1 LH

(a) Install the front stabilizer bracket No.1 LH with the 2 bolts.

Torque: 17 N*m (173 kgf*cm, 12 ft.*lbf)

HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

11. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT: Install the RH side by the same procedures as the LH side.

12. INSTALL FRONT WHEELS

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

13. INSPECT CENTER FRONT WHEEL

14. INSPECT STEERING WHEEL CENTER POINT

15. ADD POWER STEERING FLUID

16. BLEED POWER STEERING FLUID

HINT: (See page SP-26)

17. CHECK POWER STEERING FLUID LEAKAGE

18. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (See page SP-4)