Toyota Sienna Quiz
Brake control

Installation

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

HINT: Install the RH side by the same procedures with LH side.

1. INSTALL FRONT SPEED SENSOR LH

INSTALL FRONT SPEED SENSOR LH

(a) Install the speed sensor front LH with the bolt.

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE: Keep the tip of the front speed sensor LH.

INSTALL FRONT SPEED SENSOR LH

(b) Install the sensor harness clamps with the 2 bolts A and B to the body and shock absorber.

Torque: Bolt A 8.0 N*m (82 kgf*cm, 71 in.*lbf)

Bolt B 19 N*m (192 kgf*cm, 14 ft.*lbf)

NOTICE: Do not twist the sensor wire when installing the sensor.

INSTALL FRONT SPEED SENSOR LH

(c) Connect the clamp to the knuckle.

(d) Install the sensor harness and clamp to the body.

(e) Connect the speed sensor connector.

2. INSTALL FRONT FENDER LINER LH

3. REMOVE FRONT WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

4. CHECK ABS SPEED SENSOR SIGNAL

HINT: See page BC-3

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.