Installation

1. INSTALL ENGINE OIL COOLER

(a) Clean the oil cooler contact surface on the cooler mounting.

(b) Install a new O-ring to the oil cooler.

(c) Install the oil cooler assembly with the union bolt.

Torque: 68 N*m (693 kgf*cm, 50 ft.*lbf) Install the 2 water by-pass hoses with the bolt, 2 clamps, and 4 clips.

Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (See page EM-47) 3. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (See page EM-48) 4. INSTALL NO. 2 MANIFOLD STAY (See page EM-48) 5. INSTALL EXHAUST PIPE ASSEMBLY

for 2WD:(See page EX-4) for 4WD:(See page EX-10)

6. ADD ENGINE OIL (See page LU-6)

7. ADD ENGINE COOLANT (See page CO-7)

8. INSPECT FOR OIL LEAK (See page LU-6)

9. CHECK ENGINE OIL LEVEL

10. INSTALL NO. 1 ENGINE UNDER COVER (See page EM-63)