Multiplex communication

Passenger Side Outer Mirror ECU

4steps
~24min
2/5difficulty
Done 0 of 4

DTC B1208 Passenger Side Outer Mirror ECU

DESCRIPTION

This DTC is detected when communication between the outer mirror control ECU RH and multiplex network gateway ECU stops for more than 10 seconds.

DTC No.

DTC Detecting Condition

Trouble Area

B1208

Passenger side outer mirror ECU communication stops
  • Outer mirror control ECU RH
  • Wire harness

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU RH - BATTERY)

CHECK HARNESS AND CONNECTOR
  1. Disconnect the O11 ECU connector.
  2. Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

2 CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU RH - GROUND)

CHECK HARNESS AND CONNECTOR
  1. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

3 CHECK COMMUNICATION LINE

CHECK COMMUNICATION LINE
  1. Disconnect the G4 ECU connector.
  2. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

Result

Result

REPLACE OUTER MIRROR CONTROL ECU RH

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.